A bulkhead hydraulic fitting is a type of connector used to pass hydraulic fluid through a panel or barrier, such as the wall of a hydraulic reservoir or enclosure. It is designed to provide a secure and leak-free connection between hydraulic lines on either side of the barrier. These fittings are often used in applications where hydraulic systems need to be safely and efficiently routed through different compartments or sections. See full answer »

A bulkhead fitting should be tightened enough to ensure a secure and leak-free connection but not so tight that it causes damage to the fitting or the surfaces it connects. Generally, hand-tightening followed by an additional quarter to half turn with a wrench is sufficient. Always refer to the manufacturer's instructions for specific torque recommendations to avoid overtightening. See full answer »

For a 1/2 inch bulkhead fitting, you typically need to drill a hole slightly larger than the nominal size of the fitting to accommodate the threads and ensure a proper seal. Generally, a hole size of around 1 1/8 inches to 1 1/4 inches in diameter is recommended, but it's important to check the manufacturer's specifications for the exact size required for your specific fitting model. See full answer »

A bulkhead connector is used to provide a secure and reliable interface for electrical or fluid connections through a panel or enclosure. It helps maintain the integrity of the barrier, ensuring that different environments on either side remain isolated while allowing necessary connections. These connectors are commonly employed in industries like aerospace, automotive, and telecommunications to facilitate easy installation and maintenance. See full answer »

An NPT bulkhead fitting is a type of plumbing or piping component designed to pass a pipe through a barrier or wall while maintaining a secure and leak-proof connection. "NPT" stands for National Pipe Thread, a U.S. standard for tapered threads used on threaded pipes and fittings. This fitting is commonly used in applications where a fluid needs to be transferred through a tank or enclosure while ensuring a tight seal. See full answer »